D-Pillar Trim

D-Pillar Trim

Special tools, testers and auxiliary items required

• Pry Lever (80 - 200)

• Removal and installation are same for right and left.

Removing


Follow all safety precautions when working on pyrotechnic components.

- Remove the luggage compartment side trim. Refer to => [ Luggage Compartment Side Trim ] Luggage Compartment Side Trim.

- Remove the rear roof panel trim. Refer to => [ Roof Panel Trim ] Roof Panel Trim.

- Remove the expanding clips - 1 - and - 3 -.






- Remove the D-pillar trim - 2 - from the body - arrows - using the (80 - 200)

- Vehicles equipped with a speaker: disconnect the electrical connector.

Installation


• Follow all safety precautions when working on pyrotechnic components.

• Do not pinch the head curtain airbag when installing the D-pillar trim.

Installation is reverse of removal, but note the following:

• If the trim clamps remain in the body mounting points, remove them and insert them in the trim.

• Check clamps for damage or deformation, replace if necessary.

- Install the D-pillar trim and press on it until the audibly latches.

- Pull the rubber lip of the luggage compartment seal over the edge of the trim.

Tightening specifications, refer to => [ D-pillar Trim Overview ] D-pillar Trim Overview.