Floor Covering

Floor Covering

Removing

- Remove the front seat:

• Standard seat and Sport seat (manually adjustable) as well as front folding seat - passenger seat, refer to => [ Manual Standard Front Seat ] Manual Standard Front Seat.

• Standard seat, Sport seat (power) and Comfort seat, refer to => [ Power Standard Front Seat ] Power Standard Front Seat.

- Remove the rear seats. Refer to => [ Seat Frame ] Seat Frame.

- Remove the driver side instrument panel cover. Refer to => [ Driver Side Instrument Panel Cover ] Driver Side Instrument Panel Cover.

- Remove center console. Refer to => [ Center Console ] Center Console.

- Remove the center console bracket and lower the shift mechanism. Refer to => [ Center Console Bracket ] Center Console Bracket.

- Remove the rear center console vent on the center tunnel.

- Remove the front sill panel trim. Refer to => [ Front Sill Panel Trim ] Front Sill Panel Trim.

- Remove the B-pillar lower trim. Refer to => [ Lower B-Pillar Trim ] Lower B-Pillar Trim.

- Remove the rear sill panel trim. Refer to => [ Rear Sill Panel Trim ] Rear Sill Panel Trim.

- Disengage the floor covering at brackets - 1 - and - 2 -.






- Pull the floor covering - 3 - back.

• Make sure the floor covering does not tear at the openings.

- Fold the floor covering lengthwise and remove it through a door.

Installation

- Fold the floor covering lengthwise and lay it in the vehicle.

- First slide the floor covering forward until the air duct and shift mechanism openings are aligned.

- Then attach the floor covering at brackets - 1 - and - 2 -.

Further installation is performed in the reverse order of removal.