Selector Lever Boot, Separating From the Knob

Selector Lever Boot, Separating from the Knob

Removing





- Remove the knob from the selector lever. Refer to => [ Selector Lever Knob ] Selector Lever Knob.

- Bind together the spring tabs - 1 - on the selector lever knob using a cable tie - 3 - as illustrated.

- Slide the sleeve for the selector lever boot - 2 - over the tabs - arrow -.

- Remove the cable tie and remove both the sleeve and selector lever boot from the selector lever.

Installing

Install in reverse order, paying attention to the following:

Selector lever boot installed position

• The longer side of the selector lever boot frame faces toward the driver side (to the selector lever transmission range position display unit (Y26)).

- Install the knob on the selector lever. Refer to => [ Selector Lever Knob ] Selector Lever Knob.