Sealing Flange and Flywheel/Drive Plate

Sealing Flange and Flywheel/Drive Plate

• Servicing clutch:

• Observe clutch removal instructions.





1 - 15 Nm

2 - Seal

• Replacing, refer to => [ Crankshaft Seal, Ribbed Belt Side ] Service and Repair.

• Do not oil

3 - Sealing flange, front

• Must be located on dowel sleeves

• Removing and installing, refer to => [ Front Sealing Flange ] Front Sealing Flange

4 - Cylinder block

• Removing and installing crankshaft, refer to => [ Crankshaft ] Crankshaft

• Piston and connecting rod, disassembling and assembling, refer to => [ Piston and Connecting Rod ] Overhaul

5 - Dual mass flywheel/drive plate bolt

• Replace

• Dual mass flywheel tightening specifications, refer to => [ Torque specification ] Dual-Mass Flywheel

• Drive plate tightening specifications, refer to => [ Tightening Specification ] Drive Plate

6 - Dual-mass flywheel/drive plate

• Dual-mass flywheel, removing and installing, refer to => [ Dual-Mass Flywheel ] Dual-Mass Flywheel

• Drive plate, removing and installing, refer to => [ Drive Plate ] Drive Plate

• Only possible to install in one position - Bores are offset

7 - Intermediate plate

• Must be located on dowel sleeves

• Do not damage or bend when doing assembly work

• Is hooked in at sealing flange => [ Installing intermediate plate ]

8 - 15 Nm

9 - Sealing flange with rear oil seal

• Only replaced as complete unit

• To install, use provided guide sleeve

• Do not oil or grease sealing lip of oil seal

• Before installing, remove oil remains from crankshaft journal with a clean cloth

• Guide sleeve may only be removed after sealing flange has been slid onto crankshaft pin.

Installing intermediate plate





- Hook in intermediate plate at sealing flange and push it onto alignment sleeves - arrows -.