Dual-Mass Flywheel

Dual-Mass Flywheel

Special tools, testers and auxiliary items required

• Counter-holder tool (3067)

Removing

• Engine or transmission removed.

- Remove clutch pressure plate.

CAUTION!
To prevent damage to dual-mass flywheel when removing, bolts - B - must not be removed using an air-powered or impact wrench. Only removing bolts by hand is permitted.

- Rotate dual-mass flywheel - A - so that bolts - B - stand centered to holes - arrows -.





- When removing bolts - B -, make sure that bolt head does not contact dual-mass flywheel - arrows - and thereby cause damage when turning it further.

- Insert counter-holder (3067) into hole in cylinder block - B -.





- Mark dual-mass flywheel to engine.

- Remove dual-mass flywheel.

Installing

Installation is in reverse order of removal, note the following:

- Use new bolts when securing.

- Insert counter-holder (3067) into hole in cylinder block - A -.





Torque specification