Triple Roller Joint AAR 2000, Assembling

Triple Roller Joint AAR 2000, Assembling

- Slide joint protective boot onto driveshaft.

- Slide joint piece onto drive axle.

Mount triple roller star

The chamfer on star faces toward shaft, this is used as an assembly aid.

- Before installing joint or triple roller star, splines - A - must be lightly coated with grease used in joint.





- Install triple roller star onto shaft as per markings and drive in to stop.





A second mechanic is needed to slide protective boot back.

Use special tool shown in illustration.

- Insert securing ring, be sure to fit properly.

- Press 80 grams of joint grease from repair set, into triple roller joint.

- Slide joint piece over rollers and secure.

- Press 30 grams of joint grease, from repair set, into the reverse side of the triple roller joint.

- Install CV boot. The bead in the CV boot must engage in the joint piece groove.

- Remove driveshaft from vise and clamp in joint piece.

- Insert new sealing ring - arrow - from repair kit into the groove.





- Install new cover on joint. The holes of the cover and joint must align.





- Install clamp.

Observe note => [ Install clamp. ] Triple Roller Joint AAR 2600 i or 3300 i, Assembling.