All Wheel Drive

Parking Brake Cables

• The parking brake cable adjusting elements are in front of the rear lower transverse links.

Removing

- Remove the center console extension.

- Remove the wheels and tires.

- Detach the rear exhaust.

- Remove the heat shield at the rear of the fuel tank.

- Remove the rear tunnel heat shield (below the driveshaft).

- Remove the rear tunnel heat shield (above the driveshaft).

- Pull out the retaining clip - 1 - and unhook the parking brake cables at the brake caliper.





• Do not damage the parking brake boot when removing and installing.

- Unclip the brake cable - 1 - from the retainer - 3 -.





- Unclip the brake cable - 3 - from the retainer - 2 -.





- Unclip the brake cables - 1 - from the retainers - 2 - and - 4 -.





Before installing new parking brake cables you must remove the parking brake lever and reset the mechanism.

Removing and installing parking brake lever. Refer to => [ Parking Brake Handle ] Parking Brake Handle.

Installing

- Clip on the parking brake cable - 1 - until it engages.





- The clip loop on the retainer must be located between the two positioning rings - 5 -.





• Clip attachment on the retainer - 4 - must always face outside of the vehicle.

- Tighten the nuts - 3 -. Tightening specification: 1.5 Nm

- Engage the cable at exhaust mount.

- Attach the parking brake cables to the underside and the tank and insert them into the lever at the brake caliper.

• Do not damage the parking brake boot when removing and installing.

- Hook the parking brake cable into the brake caliper and insert the retaining washer - 1 -.





- Positioning rings - 1 - must align with the clips on the retainer.





- Tighten bolt - 2 -. Tightening specification: 25 Nm

- Install the heat shields.

- Adjust the parking brake. Refer to => [ Parking Brake Adjusting ] Parking Brake Adjusting.

- Install the center console extension.