HID Headlamp, MY 2007
HID Headlamp, MY 2007
CAUTION!
Risk of death due to high voltage, injury risk and environmental hazard.
• Usage and safety information for gas discharge headlamps =>
Electrical System General Information 94.
Removing
- With ignition switched off, disconnect battery Ground (GND) wire. Refer to => [ Battery, Disconnecting and Connecting ] [1][2]Battery.
Left headlamp:
- Remove the windshield washer fluid reservoir upper section and the power steering fluid reservoir. Refer to => [ Windshield Wiper Fluid Reservoir Upper Section and Power Steering Fluid Reservoir ] Windshield Wiper Fluid Reservoir Upper Section and Power Steering Fluid Reservoir.
Right headlamp - vehicles with 2.0L TFSI engine:
- Remove air filter housing, refer to => [ 2.0L TFSI ] Service and Repair.
Right headlamp - vehicles with 3.2L FSI engine:
- Remove air filter housing, refer to => [ 3.2L FSI ] Service and Repair.
Right headlamp - vehicles with 4.2L MPI engine:
- Remove air filter housing, refer to => [ 4.2L MPI ] Service and Repair.
Right headlamp - vehicles with 2.0L TDI engine:
- Remove air filter housing, refer to => [ 2.0L TDI ] Service and Repair.
Right headlamp - vehicles with 3.0L TDI engine:
- Remove air filter housing, refer to => [ 3.0L TDI ] Service and Repair.
Continuation for both sides:
- Remove bolts - 1 - and - 2 -.
- Remove low beam housing cover from headlamp housing - arrow -.
- Disengage electrical wiring at guides - arrow -.
- Disconnect electrical connector - 4 -.
- Release spring clips - 1 - and - 3 - and remove gas-discharge lamp - 2 - from housing.
Installing
Install in reverse order of removal, observing the following:
- Insert the new HID bulb into the housing without touching the bulb with bare hands.
• Observe installation position: Electrical connection must always face downward.
- Secure gas-discharge lamp with spring clips.
- Connect battery. Required actions => [1][2]Battery.
Tightening Specifications