Seat Position Sensor: Service and Repair

Driver's Seat Position Sensor Replacement

Removal

NOTE: Do not turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and do not connect the battery cable while removing the driver's seat position sensor.

1. Raise the seat all the way up.

2. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

3. Remove the recline cover. Front Seat Recline Cover Removal/Installation

4. Disconnect the seat position sensor 2P connector (A) from the driver's seat position sensor (B).

5. Remove the TORX bolt (C) and nut (D) using a TORX T30 bit, then remove the driver's seat position sensor.






Installation

NOTE:

- Be sure to install the harness so it is not pinched or interferes with other parts.

- Do not turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and do not connect the battery cable while installing the driver's seat position sensor.

1. Install the driver's seat position sensor with a new TORX bolts (A) and new nut (B).

2. Connect the seat position sensor 2P connector (C) to the driver's seat position sensor (D).

3. Reinstall the recline cover. Front Seat Recline Cover Removal/Installation

4. Do the battery terminal reconnection procedure. Procedures

5. Clear any DTCs. Initial Inspection and Diagnostic Overview

6. Check the operation of the driver's seat position sensor with the HDS. Driver's Seat Position Sensor Operation Check