Front Seat Recline Cover Removal/Installation

Front Seat Recline Cover Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

- Take care not to tear or damage the seat covers.

- Put on gloves to protect your hands.

1. Remove the front seat. Front Seat Removal/Installation

2. Remove the screw, and release the hook (A), the tabs (B), and the pin (C), then remove the front cover (D). The driver's seat is shown; the passenger's seat is symmetrical.

3. From under the seat cushion, release the seat-back hooks from the seat cushion frame springs. Front Seat-Back Cover Replacement






4. Remove the recline cover (A).
-1 Remove the screws, and detach the clip.
Detach the tabs (B).
-3 Pull up the cover, then release the hooks (C).
Disconnect the power seat adjustment switch connector (D) and the lumbar support switch connector (E).
-5 Remove the wire harness (F) from the hooks (G).

Driver's seat





Passenger's seat





5. Remove the center cover (A). The driver's seat is shown; the passenger's seat is symmetrical.
Remove the screw.
-2 Pull up the cover, then release the tab (B).

6. Install the recline cover in the reverse order of removal. Push the clips, the hooks, and the tabs into place securely.