Front Safety Belt Retractor

Operation number: 88408-2

Front safety belt retractor

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Removal

Note! Removal steps in this procedure may contain installation details.





Disconnect the battery ground cable.

Information about the handling and storage of pyrotechnic SRS components. Refer to: Handling non-deployed pyrotechnical part Handling Non-Deployed Pyrotechnical Part.


Warning! A pyrotechnical SRS component must never be unscrewed, repaired or transferred to another vehicle.


Warning! Do not use measuring equipment on the supplemental restraint system (SRS) electrical connector.

Remove the panel. Refer to: B-pillar trim panel B-Pillar Trim Panel.





Remove the electrical connector. Refer to: Igniter wire connector Igniter Wire Connector.
Torque: Safety belt retractor front to body, 40 Nm

Installation

To install, reverse the removal procedure.

Check the safety belt function. Refer to: Seat belt function, check Seat Belt Function, Check.

Carry out a post check. Refer to: Supplementary restraint system (SRS), inspection Testing and Inspection.