Vehicle Lifting: Locations

Jacking points body frame

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Jacking points in body frame

Jacking points for lifting the vehicle, option A




The following jacking points must be used when lifting the vehicle. The jacking plate must have a rubber pad to prevent damage to the vehicle.

Jacking points for lifting the vehicle, option B




The following jacking points must be used when lifting the vehicle. The jacking plate must have a rubber pad to prevent damage to the vehicle.

Front lift:
A wooden load relief plate (200*200*20 mm) must be used behind the sub-frame bracket.

Rear lift:
A wooden spacer (170*80*50 mm) must be used in front of the sub-frame bracket.