Anti-Roll Bar Link Front, Replacing

Anti-roll bar link front, replacing

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Removing the anti-roll bar link





Remove:
- the wheel
- the anti-roll bar link from the mountings. Use socket 999 5500 SOCKET UPPER NUT REAR SHOCK ABSORBER 999 5500 Socket Upper Nut Rear Shock Absorber and a Torx wrench as a counterhold so that the boot is not damaged.

Installing the anti-roll bar link

Install:
- the anti-roll bar link in the spring strut. See: Tightening torque [1][2]Specifications
- the anti-roll bar link in the anti-roll bar. See: Tightening torque [1][2]Specifications.

Note! Use socket 999 5500 SOCKET UPPER NUT REAR SHOCK ABSORBER 999 5500 Socket Upper Nut Rear Shock Absorber and a Torx wrench as a counterhold so that the boot is not damaged.

- the wheel. See Installing wheels Service and Repair.