Front Seat

Front seat

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal







Removing the front seat




Adjust the seat to its rear most position.

Remove:
- the 2 seat runners
- the 2 M10 screws.
Adjust the seat to its front most position.

Ignition off




Disconnect the battery negative cable.

Removing the front seat, continued





Remove:
- the panel at the seat belt anchorage
- the 2 seat runners





Remove:
- the 2 M10 screws
- the M10 screw of the lower belt anchorage.
Lift up the rear edge of the seat and remove the belt rod.
Remove the connector screw

Caution! Two people are required for this task to prevent damage to the interior trim or the seat.

Lift out the seat.

Installation

Installing the front seat

Note! For tightening torques, see: Tightening torque, B5254T7 [1][2]Body and Frame.

Install in the reverse order.