Blower Motor Passenger Compartment, L.H.D

Blower motor passenger compartment

Special tools:
999 7115 Counterhold 999 7115 Counterhold

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Important information and removing components

Caution! Do not touch the fan motor's fan rotor. This is to avoid damage to the fan blades, which can cause imbalance in the fan rotor.

Note! Do not place the fan motor on the fan rotor.

Remove:
- the instrument panel, according to Dashboard Dashboard




- the air quality sensor (AQS)
- the connector for the damper motor module (DMM) recirculation
- the damper motor module (DMM) recirculation. See: Actuator recirculation Damper Motor Recirculation, Replacing
- the 3 screws for the air distribution damper cover
- the cover for the air distribution damper.

Removal

Removing the blower fan motor




Press in the catch on the connector for the fan motor and pull straight out.




Press the lock button (1).
Turn the fan motor counter-clockwise to the limit position (2).




Remove the fan motor from the passenger side. Use: 999 7115 Counterhold 999 7115 Counterhold.

Installation

Installing the blower fan motor




Place the fan motor in the correct position for installation. Use: 999 7115 Counterhold 999 7115 Counterhold.

Note! Turn the fan motor to the position for installation.

Insert the fan motor from the driver's side. Turn clockwise to the limit position.
Connect the connector.

Install:
- the cover for the air distribution damper using the 3 screws. Tighten
- the damper motor module (DMM) recirculation. See: Actuator recirculation Damper Motor Recirculation, Replacing
- the connector for the damper motor module (DMM) recirculation
- the air quality sensor (AQS).

Finishing

Testing the fan motor
Test the operation of the fan motor.
Install the dashboard. See: Dashboard Dashboard.