Sunroof / Moonroof Windguard: Service and Repair

Wind deflector sunroof

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing wind deflector sun roof




Open the sun roof completely.
Press the end of the wind deflector (1) using a screwdriver.

Caution! Do not damage the painted surfaces.

At the same time pull the wind deflector carefully backwards (2) until the locking tab at the front edge releases.
Carry out the same operation on the other side.
Lift up and remove the wind deflector.

Installation

Installing the wind deflector for the sun roof
Insert the ends of the wind deflector into the grooves on the sides and past the lock grooves in the rear edge.
Bend the wind deflector down and position the locking tabs in under the edge of the panel.
Ensure that the ends have engaged in the lock grooves.

Caution! Do not damage the painted surfaces.

Finishing

Recalibration of the electric motor/sun roof module (SRM)
Recalibrate of the electric motor/control module. See: Electric motor / sun roof module (SRM), calibration Electric Motor/Sun Roof Module (SRM), Calibration.