Seat Latch: Service and Repair

Load limiter rear locking

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal






Remove:
- the rubber strip
- the M6 screw.
Move the rear locking upwards.





Remove the connector.






Remove:
- the locking washer
- 1 screw.
Pull out the shaft.






Remove:
- the mounting bracket
- the cradle
- the spring
- the ring.





Remove 1 screw.

Installation

Torque tighten. See.
Install in the reverse order.