Headlamp: Adjustments

Headlamps, adjusting

Operation number: 35202-2

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Adjustment

Caution! Vehicles equipped with Bi-Xenon lamps or halogen lamps are adjusted in the same way. To ensure that the position sensor for the Bi-Xenon lamps is correctly calibrated calibrate as follows.

Calibrate position sensor Bi-Xenon lamps using appropriate procedure.

Note! After calibrating the position sensor, the ignition must be turned off and on before headlamp alignment is started.

Caution! Always adjust the headlamp beam according to the legal requirements of the market.




Move the beam level switch to 0.
Ignition and low beam on.

Applies to vehicles with fog lamps




Adjust the beam horizontally (X) by turning the Allen screw. See the graphic.

Applies to headlamps





Note! Always adjust the beam with low beam switched on.

Adjust the beam vertically (Y) by turning the Allen screw. See the illustration.
Adjust the beam horizontally (X) by turning the Allen screw. See the illustration.

Beam

Note! Adjust according to the illustration for the applicable market.

All markets except USA, United Kingdom and Japan.





USA





Great Britain





Japan