Brake Disc Rear, Checking

Brake disc rear, checking

Note! Some variation in the illustrations may occur, but the essential information is always correct.






Removal

Note! Removal steps in this procedure may contain installation details.

Remove the following items:
- wheels. Refer to: Wheels Service and Repair
- the retaining screws to the brake caliper holder. Use new screws for installation.




999 7104 Clamp ring 999 7104 Clamp Ring.
Make sure that the contact surfaces of the brake disc and clamping ring are clean. Fit the screws, but only tighten slightly.
Tighten crosswise to 90 Nm. 981 4031 Torque socket 19 mm 981 4031 Torque Socket 19 mm




999 5418 Measuring kit 999 5418 Measuring Kit
Fit the bracket that is part of the measuring equipment. Use the brake caliper's retaining screw.




Fit the dial indicator in the bracket. Position the dial indicator's tip toward the brake disc.
Slowly rotate the brake disc. The maximum lateral runout of the hub should not exceed 0.025 mm.
If lateral runout exceeds 0.025 mm, replace the brake disc. Refer to: Rear brake disc Rear Brake Disc.

Note! Always check the wheel hub's lateral runout before installing a new brake disc. Refer to: Wheel hub rear, checking Wheel Hub Rear, Checking.

Installation

To install, reverse the removal procedure