Side Panel Loadspace

Side panel loadspace

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the side panel in the cargo compartment





Remove:
- the outer load floor.




- the 2 covers.

Hint: Use an electrician's screwdriver to remove the cover.

Remove:
- the screws, 1 per loading eye, and remove the loading eyes.




- the 1 screw. Remove the panel over the seat belt reel.




- 1 screw.




Remove the sealing trim strip.

Remove:
- the side cushion. See: Side pad Rear Seat
- the lower panel on the C post. It is secured with 4 clips.
Detach the molding in the door opening by the C-post panel.




Start at the rear edge of the side panel. Pull the panel straight out so that the 2 clips release.
Repeat the procedure at the front edge so that the 1 clip releases.

Installation

Note! For tightening torques, see Specifications. [1][2]Body and Frame

Installing the side panel in the cargo compartment




Press the side panel into place. Start at the front edge.

Hint: Detach the sill trim panel. Pull the sill trim panel straight up so that it is easier to install the side panel in the rear edge.




Press the lower part of the panel on the C-post into place.

Install:
- the molding in the door opening
- 1 M5 screw. Tighten.
- the panel over the seat belt reel. Use the 1 M5 screw. Tighten
- the loading eyes using the 2 M8 screws. Tighten
- the 2 covers for the loading eyes
- the outer load floor.
- the side cushion, see: Side pad Rear Seat.