Drive Belt: Service and Repair

Auxiliary belt

Operation number: 21581-2

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Removal

Note! Removal steps in this procedure may contain installation details.

Remove the upper engine stabilizer brace. Refer to: Upper torque rod, B6304T2, B6324S, B8444S Upper Torque Rod

Torque: M10, 50 Nm

Torque: M6, 10 Nm

Torque: M8, 24 Nm

Caution! Relieve the load on the belt tensioner by turning it clockwise to max. 230 Nm and lock the tensioner with relevant tool.

Caution! Ensure that 230 Nm is not exceeded when the belt tensioner is relieved. The torque takes more than 20 seconds to carry out without risk of affecting the belt tensioner.

999 7195 Holder 999 7195 Holder

Installation

To install, reverse the removal procedure