Brake Hose Front, Replacing

Brake hose front, replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work




Secure the pedal in the depressed position. Use a pedal jack.
Remove the protective cap from the bleed nipple at the left front wheel. Install a plastic hose on the nipple.
Open the bleed nipple. Collect the brake fluid in a container.
Shut the bleed nipple.

Removal

Remove the brake hose





Remove:
- the brake hose from the brake pipe (1)
- the brake hose from the brake caliper (2).

Installation

Install the brake hose

Note! For tightening torques, see: Tightening torque Tightening Torque.





Install:
- the brake hose to the caliper (1). Tighten. See: Tightening torque Tightening Torque
- brake pipe in the hose (2). Tighten. See: Tightening torque Tightening Torque.

Check the brake hose
Ensure that the brake hose is not twisted. If necessary alter the hose at the other end (brake pipe end).

Note! If the brake hose is twisted it may rub against the tire, rim or wheel arch. This could cause the circuit to fail.

Top up with brake fluid and bleed the braking system. See: Brake system, bleeding (using bleeding unit) Brake System, Bleeding (Using Bleeding Unit).
Install the wheel. See: Installing wheels Service and Repair.