Control System, Replacing

Control system, replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the cable harness
Remove the cable harness from the control system. See: Cable harness, control system, gearbox, replacing Service and Repair.





Note! Protect the cable harness by taping it to the outside of the transmission.

















Installation

Note! For tightening torques, see applicable specifications.





Caution! Ensure that the cable harness is not trapped when the control system is positioned.




Lightly tighten.




Use new screws and a new gasket.
Lightly tighten.




Tighten alternately, M6.

Installing the cable harness
Install the cable harness for the control system. See: Cable harness, control system, gearbox, replacing Service and Repair.