Rear

Rear Stabilizer Bar

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing diagonal stays




Remove the screw on both sides.

Removing the anti-roll bar




Remove the 2 nuts (1) holding the anti-roll bar in the lower control arms. Use a Torx wrench as a counterhold so that the boot is not damaged.





Remove:
- the 4 screws holding the anti-roll bar in the sub-frame
- the anti-roll bar.

Installing the anti-roll bar

Note! For tightening torques, see Specifications. [1][2]Specifications





Install:
- the anti-roll bar
- the 4 M10 screws.




The 2 x M10 nuts (1).

Installing diagonal stays




Install the diagonal stays with screws M12, 2 pcs. Tighten securely. [1][2]Specifications