Seat Belt Retractor, Rear

Seat belt retractor, rear

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Disconnecting the battery cable




Switch off the ignition.
Disconnect the battery negative lead. See: Battery Disconnecting.

Warning! For information about the handling and storage of pyrotechnic SRS units, see: Handling non-deployed pyrotechnical part Handling Non-Deployed Pyrotechnical Part.

Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected, non-deployed pyrotechnic SRS unit. There is a risk of the seat belt tensioner deploying.

Warning! A pyrotechnic SRS unit must never be disassembled, repaired or moved to another vehicle.

Removal

Removing the inertia reel





Remove:
- the anti-roll bar panel (ROPS) as described in Rollover Protection Unit Trim Cover Service and Repair
- the igniter cable
- the screw of the gas generator.




Remove the M8 screw of the inertia reel.

Installation

Installing the inertia reel

Note! For tightening torques, see Specifications. [1][2]Body and Frame.

Install the components in reverse order.