Brake Fluid Reservoir: Service and Repair

Reservoir, brake fluid

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Remove the master cylinder. Master Cylinder, Brake, L.H.D

Removal

Removing the brake fluid reservoir





Remove:
- the 1 screw on the side of the brake fluid reservoir
- the reservoir.

Note! Clean around filler cap at the connector between the reservoir and master cylinder. This is to ensure that no contaminants enter the brake system.

Installation

Installing the brake fluid reservoir

Note! For tightening torques, see Specifications. Tightening Torque.

Note! Check the seals. Replace if necessary. Only use brake fluid to lubricate the seals in the brake system.

Install:
- the brake fluid reservoir
- the 1 screw on the side of the brake fluid reservoir. Tighten. See: Tightening torque Tightening Torque
- the master cylinder. Master Cylinder, Brake, L.H.D