Brake Disc Front, Replacing

Front brake disc

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work





Remove:
- the wheel
- the brake pads. Brake Pads, Front
- the 2 screws
- the mounting bracket.

Removing the brake disc





Remove:
- the lock clip and discard it. This is only used during the production process.
- the brake disc.

Cleaning and checking

Cleaning and checking brake discs

Note! Cleaning is important to prevent lateral run out at the brake disc.

Clean the hub flange before installing the new brake disc.
Check the hub. If it is damaged, measure the lateral runout. See: Wheel hub front, checking Wheel Hub Front, Checking.

Installing the brake disc

Note! For tightening torques, see Specifications. Tightening Torque.

Caution! Be careful when handling the new brake disc. Careless handling can cause damage to the brake disc (out-of-true).

Install the brake disc.

Finishing

Install:
- the mounting bracket
- the 2 screws. Tighten. See: Specifications. Tightening Torque
- the new brake pads. Brake Pads, Front
- the wheel. Service and Repair

Note! Use new brake pads.

Depress the brake pedal a few times. Check the fluid level in the brake fluid reservoir. Top up if necessary.