Load Limiter Rear Locking

Load limiter rear locking

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal





Remove:
- the rubber strip
- the M6 screw.
Move the rear locking upwards.




Remove the connector.





Remove:
- the locking washer
- 1 screw.
Pull out the shaft.





Remove:
- the mounting bracket
- the cradle
- the spring
- the ring.




Remove 1 screw.

Installation

Torque tighten. See: Tightening torque [1][2]Body and Frame.
Install in the reverse order.