Procedures

Wheel knuckle / spring strut, calibrating

Measuring before removal




The measurements are made so that the same camber angle can be obtained when installing.
Measure over the wheel spindle / spring strut at the upper screw as illustrated.
Before measuring clean off any dirt from the measuring surfaces.
Note the measurement.

Installing the spring strut / wheel spindle




Install the spring strut on the wheel spindle. Use new screws and nuts.
Adjust in accordance with the measured values.
Tighten to 105 Nm. Angle-tighten 90°. Use bevel protractor 951 2050 BEVEL PROTRACTOR 951 2050 Bevel Protractor.