End Mounting, Replacing

End mounting, replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing front end mountings




Move the front seat as far forward as possible.
Remove the side panel. See: Side panel Side Panel Front Seat, Replacing (-2004) or: Side panel front seat, replacing Side Panel Front Seat, Replacing (2005-).

Note! Use a weatherstrip tool to disconnect the seat belt from the end mounting. Carefully press the locking tab, as illustrated.

Remove the screw from the seat. Remove the end mounting.

Installation

Installing front end mountings

Note! For tightening torques, see:.





Install:
- the end mounting
- the M10 screw. Tighten.
Press the seat belt into the end mounting.

Note! A clear click is heard when the seat belt has locked correctly with the end mounting.

Note! Also check that the seat belt has locked correctly with the end mounting by looking at the reverse of the end mounting.

A= Correctly locked position.
B= If the lock facing does not lock correctly with the end mounting, see A, replace the end mounting with a new one.

Note! Check that the seat belt is secure by jerking it hard in an upwards direction.

Reinstall the side panel. See: Side panel Side Panel Front Seat, Replacing (-2004) or: Side panel front seat, replacing Side Panel Front Seat, Replacing (2005-).