Floor Console

Floor console

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing center tunnel console




Using a knife, loosen the handbrake lever boot from the side (1).
Angle out the boot from the center console (2).




Pull off the boot from the handbrake lever.




Remove the panel inside the center console. It is secured with 4 hidden clips.





Remove:
- the center console. See: Center console Center Console
- the 2 connectors. See: Power socket 12V Power Socket 12V
- the panel under the cover / armrest
- the 4 screws
- the 2 connectors (1).




Lift the rear edge of the center console. Then lift the center console forwards / upwards.

Transferring components

Transferring components center console

Transfer:
- the cup holder. See: Floor Console Cup holder Floor Console Cup Holder
- the rear cigarette lighter socket. See: Extra power socket 12V Extra Power Socket 12V
- the cover / armrest. See: Cover/armrest tunnel compartment Cover/Armrest Tunnel Compartment
- the front storage compartment. See: Storage compartment front center console Storage Compartment Front Center Console.

Installation

Installing the center console
Align the center console.

Install:
- the 2 connectors
- the 4 screws. Tighten
- the panel under the cover / armrest
- the 2 connectors. See: Power socket 12V Power Socket 12V
- the center console. See: Center console Center Console
- the panel inside the center console. It is secured with 4 hidden clips.
Guide the boot over the handbrake lever.
Angle in the frame of the boot.
Press the boot into position on the side.