Front Door Window Motor: Service and Repair

Electric motor, lift mechanism, front door

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the electric motor window lift mechanism





Caution! The control module and the electric motor must not be separated.

Remove:
- the door panel as described in Panel front door Panel Front Door
- the connectors, x3
- the 3 screws
- the lift motor.

Installation

Installing the electric motor window lift mechanism

Note! For tightening torques, see Specifications. [1][2]Body and Frame

Install:
- the lift motor
- the 3 x M6 screws. Tighten.
- the connectors, x3
- the door panel as described in Panel front door Panel Front Door.

Ordering software

Note! The control module must be programmed after replacing the lift motor.

Program the control module on the driver's side. See: 30739648.
Program the control module on the passenger side. See: 30739647.
Initiate the window regulator.