Hydraulic Cylinder, Front Roof Panel

Hydraulic cylinder, front roof panel

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Remove the center headlining as described in Convertible Top Center Headliner Convertible Top Center Headliner.








Use the buttons to release the front roof catch and the catch between the center and rear roof panels.
Relieve the oil pressure in the hydraulic pump. See: Convertible Top Hydraulic System Pressure Relief Convertible Top Hydraulic System Pressure Relief.

Removal





Note! Two people are required for this task.

Lift up the front roof panel and place it carefully on the center roof panel.





Note! Note the location of the plastic washers and sleeve.

Remove:
- the lock pin of the lock rod. Detach and move aside the rod
- the hydraulic cylinder retaining clip
- the 2 shafts
- the hydraulic cylinder.




Remove the 2 retainers of the hydraulic hoses.

Note! Mark the hoses before replacement.

Caution! Risk of oil spill. Use protective paper. O-rings must always be replaced.

Installation

Install in the reverse order.

Caution! Check the function of the roof by operating it from the closed position to the open position and then closed again. Check the fluid level in the hydraulic pump's expansion tank. Fill with fluid as necessary, part no. 3074 1424.