Convertible Top Primary Lift Cylinder

Convertible Top Primary Lift Cylinder

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Remove the side panel in the rear seat as described in Side panel rear seat Side Panel Rear Seat.




Relieve the oil pressure in the hydraulic pump. See: Convertible Top Hydraulic System Pressure Relief Convertible Top Hydraulic System Pressure Relief.

Removal





Remove:
- the hydraulic cylinder retaining clip
- the washer
- the shaft




- the speaker as described in Rear Quarter Panel Speaker Rear Quarter Panel Speaker
- the cover, 3 x clips
- the 2 M6 nuts
- the 2 brackets













Note! Mark the hoses before replacement.

Caution! Risk of oil spill. Use protective paper. O-rings must always be replaced.

Installation

Note! For tightening torques, see Specifications. [1][2]Body and Frame.

Install in the reverse order.

Caution! Check the function of the roof by operating it from the closed position to the open position and then closed again. Check the fluid level in the hydraulic pump's expansion tank. Fill with fluid as necessary, part no. 3074 1424.