FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Gear Selector Lever Assembly, Replacing






Gear selector lever assembly, replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing components

S60R (B5254T4 engine)
Remove center console. See: Service and Repair

S60 (other engines)
Remove center console. See: (-2004) or (2005-) Service and Repair.

V70R (B5254T4 engine)
Remove center console. See: Service and Repair

V70 (other engines)
Remove center console. See: (-2004) or (2005-) Service and Repair.

V70XC/XC70
Remove center console. See: (-2004) or (2005-) Service and Repair.

XC90
Remove center console. See: Center console, replacing Service and Repair.

S60 and V70
Remove the gear selector lever knob. See: Gear Selector Knob, Replacing

XC90
Remove the gear selector lever knob. See: Gear selector lever knob, replacing Gear Selector Lever Knob, Replacing

Removing the gear selector cable from the ball joint





Hint: The screw on the puller is turned counter-clockwise to pull the gear selector cable loose.

Remove the gear selector cable from the ball joint. Use: 999 7071 Puller 999 7071 Puller.

Removing the gear selector assembly





Remove:
- the connector
- the screws for the gear selector assembly. Lift the gear selector assembly and twist it so that the lower gear selector cable is accessible.

Removing the gear selector cable from the ball joint and gear selector assembly





Hint: The screw on the puller is turned counter-clockwise to pull the gear selector cable loose.

Remove the gear selector cable from the ball joint. Use: 999 7071 Puller 999 7071 Puller. Carefully pry up the catches (1) and slide the cable sleeves upward on both gear selector cables.

Installation

Note! For tightening torques, see: Tightening Torque

Installing the cables and the gear selector assembly





Install:
- the gear selector cables on the levers on the gear selector assembly. Press the cable sleeves onto the gear selector assembly by hand
- the gear selector assembly on the bodywork (M8)
- the connector on the gear selector assembly.

Finishing

S60 and V70
Install the gear selector lever knob. See: Gear Selector Knob, Replacing
Install the gear selector lever knob. See: Gear selector lever knob, replacing Gear Selector Lever Knob, Replacing.

S60R (B5254T4 engine)
Install the center console. See: Service and Repair

S60 (other engines)
Install the center console. See: (-2004) or (2005-) Service and Repair.

V70R (B5254T4 engine)
Install the center console. See: Service and Repair

V70 (other engines)
Install the center console. See: (-2004) or (2005-) Service and Repair.

V70XC/XC70
Install the center console. See: (-2004) or (2005-) Service and Repair.

XC90
Install the center console. See: Center console, replacing Service and Repair.