Relay Electrical Engine Block Heater, Replacing

Relay electrical engine block heater, replacing

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Preparatory work




Remove the locking plate for the headlamp as illustrated.
Disconnect the connector.
Remove the headlamp.

Removing the relay for the electric engine block heater





Remove:
- the tie straps
- 2 screws. Pull out the engine block heater relay
- the locking sleeves for the cable splices. Disconnect the wiring
- the engine block heater relay.

Installation

Installing the relay for the electric engine block heater





Connect the wiring:
- front engine block heater socket (1)
- engine block heater (2)
- passenger compartment socket (3) if applicable.




Connect the ground lead (4).
Install locking sleeves for the cable splices.
Position the engine block heater relay under the plate (1).
Install the screws (2). Clamp the cables (3, 4).

Finishing work
Connect the connector for the headlamp.
Install the headlamp.
Install the locking plate for the headlamp.
Test the function.