Wiper Motor Linkage: Adjustments

Control links / wiper mechanism, adjusting

Adjustment

Control arms




- Detach the control arms from the link arm
- Remove the nut from the link arm
- Run the motor to the parked position
- Adjust the position of the link arm. The link arm must be parallel with the outer control arm
- Apply thread sealant liquid P/N 9961053-2 to the threads of the motor shaft
- Tighten the nut. Use a 20 mm fixed wrench on the link arm as a counterhold
- Install the control arms
- Test drive the mechanism.

Other information
To replace windshield wiper components. See Wiper mechanism and wiper motor, windshield, replacing Wiper Mechanism and Wiper Motor, Windshield, Replacing