Removal and Replacement

Throttle body (electronic throttle module), replacing

Removal and Installation

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Removing the throttle body (TB)





Remove:
- the battery negative lead. Battery, disconnecting Battery Disconnecting
- the air intake between the front cover plate and the air cleaner (ACL) housing
- the charge air pipe between the throttle body (TB) and the charge air cooler (CAC).




Disconnect the throttle body (TB) connector.
Remove the 4 screws for the throttle body (TB).
Remove the throttle body (TB) and the gasket. Clean the mating surfaces thoroughly.

Installing the throttle body (TB)

Install:
- the throttle body (TB). Use a new gasket. Tighten. Connect the throttle body (TB) connector
- the pipe between the throttle body (TB) and the charge air cooler (CAC)
- the intake manifold between the front cover plate and the air cleaner (ACL) housing
- the battery negative lead. Battery, disconnecting Battery Disconnecting.

Note! After replacing the throttle unit, the throttle unit must be adapted using the vehicle communication input: "Adaptation of the electronic throttle unit".

Remedy as necessary.