Seat Belt Retractor, Rear

Seat belt retractor, rear

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Disconnecting the battery lead




Ignition off.
Disconnect the battery negative cable. See: Battery Disconnecting

Warning! For information about the handling and storage of pyrotechnical SRS units, see: Handling non-deployed pyrotechnical part Handling Non-Deployed Pyrotechnical Part

Warning! Never measure with an ohmmeter or other live measuring instrument on a disconnected, non-deployed pyrotechnical SRS unit. There is a risk of the seat belt tensioner deploying.

Warning! A pyrotechnical SRS unit must never be dismantled, repaired, or moved to another vehicle.

Removal

Removing rear outer seatbelt




Raise the seat cushion.

Remove:
- the parcel shelf. See: Parcel shelf Service and Repair
- connector for the belt roller (retractor)
- the nut, 1 pc., for the belt roller (retractor)
- the screw, 1 pc., for the end fitting.
Replace the belt roller (retractor) with pre-tensioner.

Removing rear middle seatbelt





Remove:
- upholstery. Seat Cushion, Rear Seat
- plastic casing. It is installed with hooks, 4 pcs.




- the nut, 1 pc., at the top
- the screw, 1 pc., at the bottom.
Extract the seatbelt and remove it.

Installation

Installing rear middle seatbelt
Insert the seatbelt.

Install:
- the nut, M10 x1
- the M10 screw.
Tighten the nut and screw according to: Tightening torque [1][2]Body and Frame.
Hook on the plastic casing.
Install the upholstery. Seat Cushion, Rear Seat

Installing rear outer seatbelt

Install:
- belt roller (retractor)
- the nut, 1 pc. for the belt roller (retractor). Tighten, see: Tightening torque [1][2]Body and Frame
- end fitting
- the screw, 1 pc., for the end fitting. Tighten, see: Tightening torque [1][2]Body and Frame
- connector for the belt roller (retractor)
- the parcel shelf. See: Parcel shelf Service and Repair.
Lower the seat cushion.

Finishing

Checking the function
Check the function of the belt as described in Seat belt function, check Testing and Inspection.
Carry out an inspection as described in Supplementary restraint system (SRS), inspection Component Tests and General Diagnostics.