Reservoir, Brake Fluid, R.H.D

Reservoir, brake fluid

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Removing the master cylinder
Remove the master cylinder. See: Master cylinder, brake, R.H.D Master Cylinder, Brake, R.H.D

Removal

Removing the brake fluid reservoir





Remove:
- the 1 screw on the side of the brake fluid reservoir
- the reservoir.

Note! Clean around filler cap at the connector between the reservoir and master cylinder. This is to ensure that no contaminants enter the brake system.

Installation

Note! For tightening torques, see Specifications. Tightening Torque

Installing the brake fluid reservoir

Note! Check the seals. Replace if necessary.

Note! Only use brake fluid to lubricate the seal rings in the brake system.





Install:
- the brake fluid reservoir -
- the 1 screw on the side of the brake fluid reservoir. Tighten. See: Tightening torque Tightening Torque.

Installing master cylinder
Install the master cylinder. See: Master cylinder, brake, R.H.D Master Cylinder, Brake, R.H.D

Finishing

Bleeding brake systems
Bleed the brake system. See: Brake system bleeding Brake System Bleeding.
Check that the brake pipe connections are sealed.
Check the brake fluid level.