Front Seat Backrest

Front seat backrest

Special tools:
115 8962 CRIMP PLIERS 115 8962 Crimp Pliers

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing backrest cushion upholstery
Remove the front seat. See: Front seat Front Seat.
Slacken off the tension in lumbar support.
Carefully detach the cover for the lumber support adjustment knob. Pull the lumber support adjustment knob straight out.
Press down the 2 catches in the underside of the protective pad. Press through the upholstery.
Lift the head restraint upwards while the catches are pressed in.
Remove the head restraint.
If the front seat is manually operated, remove the backrest adjustment knob. Pull the knob straight out.
Fold the backrest cushion backwards if it can be folded. If the backrest cushion cannot be folded, position it in the forward angled position.




Remove the upholstery. Start at the bottom edge and continue upwards along the entire backrest cushion. Cut off the 12 half moon clips as the upholstery is pulled up on the front.




Unhook the Velcro seam on the reverse and remove the upholstery.

Installation

Installing backrest cushion upholstery




Fit the upholstery over the backrest cushion and secure the half moon clips as the upholstery is pulled down. Use: 115 8962 CRIMP PLIERS 115 8962 Crimp Pliers.

Install:
- the Velcro seam on the reverse of the backrest cushion
- the upholstery at the bottom edge
- the lumber support adjustment knob and its cover
- the backrest adjustment knob (if applicable).
Install the head restraint. Press the head restraint down until the catches engage.

Note! Lift in the head restraint and check that it cannot be moved upwards.

Install the front seat. See: Front seat Front Seat.