Drive Shafts, Installing

Installing drive shafts

Note! The method is the same for the left and right drive shafts unless otherwise stated. Preparations: Check that the ABS sensor and pulse wheel are free of dirt.

Installing the right drive shaft on the transmission
See Transmission, installing .

Installing the left drive shaft on the transmission
See Transmission, installing .

Installing the drive shaft on the hub
See Transmission, installing .

Installing the ball joint on the stub axle
See Transmission, installing .

Tightening the drive shaft screw(s)
See Transmission, installing .

Installing the bracket for the brake pipe / ABS cable




Install the bracket for the brake pipe / ABS cable.

Note! Ensure that the ABS sensor seating is absolutely clean!

First clean the ABS sensor using a soft brush. Then install it on the stub axle. Tighten to 10 Nm .

Install the front wheel