Fuel Door: Service and Repair

Lock unit fuel tank filler cover, replacing

As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Removing the lock unit for the fuel tank filler cover




Fold up the cargo floor hatch.

Remove:
- the outer load floor
- the hatch (the rear section of the side panel in the cargo compartment).
Fold the insulation out of the way.
- the two screws holding the bracket in the body
- the connector
- two screws holding the lock unit on the bracket.

Installing the lock unit for the fuel tank filler cover

Install:
- the two screws holding the lock unit on the bracket
- the two screws holding the bracket in the body
- the connector.
Reinstall the insulation.

Install:
- the hatch (the rear section of the side panel in the cargo compartment)
- the outer load floor.
Fold down the cargo floor hatch.