Gear Selector Lever Assembly, Replacing

Gear selector lever assembly, replacing

Note: As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the center console
Remove the center console.

Removing the gear selector knob
Remove the gear selector knob.

Removing the top panel from the gear selector assembly
Remove the top panel.

Removing the gear selector assembly and cables

Remove:





- the catch for the cable at the gear selector lever
- the cable from the end of the gear selector assembly
- the key lock cable. Pry out the yellow locking sleeve slightly. Lift the cable up from the gear selector assembly
- the 4 screws.

Removing the solenoid





Transfer the solenoid and connector to the new gear selector unit

Installation






Note: For tightening torques, see Specifications.

Installing the cables and gear selector assembly
Tighten to 25 Nm.

Install:
- the mechanical cable to the gear selector. Secure the cable with the catch
- cable on the gear selector nose
- the key lock cable to the gear selector assembly.

Place the cable in the extracted locking sleeve the cable will be adjusted).

Initial setting of the key lock cable (adjusting)
See Gear selector lever assembly Geartronic replacing.

Installing the top panel on the gear selector assembly
Install the top panel and boot.

Installing gear selector knob
Install the gear selector knob.

Installing the center console
Install the center console.