Gear Selector Lever Knob, Replacing

Gear selector lever knob

- Pry off the rear edge of the gear selector lever cover together with the boot until the two clips release. Use a plastic weatherstrip tool. Remove the gear selector lever cover and the boot
- Then pull the panel up until the four clips at the sides release.

- Lift the boot up over the gear selector lever to access the locking sleeve
- Press in the two catches on the locking sleeve. Pull the locking sleeve downwards.

- Grip the gear selector lever knob using both hands
- Pull the knob straight up with force.

- Take the new gear selector lever knob. Ensure that the support ring is straight in its groove in the gear selector lever
- Press the knob down over the support ring so that it locks.

- Pull up the panel with the boot towards the gear selector lever knob
- Pull the locking sleeve up to the gear selector lever knob. Turn the locking sleeve slightly so that the guide (1) inside the locking sleeve is correctly positioned on the notch (2) on the gear selector lever knob
- Pull the locking sleeve until it locks. Check that the locking sleeve is securely mounted on the gear selector lever knob. Pull the gear selector lever knob to check that it is securely mounted
- Lower the panel. Press the panel into place in the centre console.