IC (Inflatable Curtain) Module, Replacing

IC (inflatable curtain) module, replacing

Special tools:
951 1506 Test dummy 951 1506 Test Dummy

Deployed IC (inflatable curtain)

The following components must be check and replaced where necessary if the SRS system has deployed:
- IC (inflatable curtain)
- Headlining
- The panels for the A, B and C/D-posts.

Preparation




Disconnect the battery lead.
See Battery, disconnecting Battery Disconnecting.

Note! Do not fold or twist the inflatable curtain during removal or installation. No components may be opened. Do not remove, slacken off or interfere with any part of the component.

Note! The inflatable curtain module must be handled with both hands, with one hand around the gas generator.

Note! The inflatable curtain module must be kept level.

Note! Avoid twisting or bending the inflatable curtain module.

Note! The inflatable curtain module must be returned if it is "visible damaged".





Note! Do not position or install accessories or any other components in the area marked in the illustration. Failure to observe this instruction may cause the IC (inflatable curtain) to fail.

Removing inflatable curtains




First read Preparation.

Note! The hose clamp must not be opened under any circumstances. If the clamp is opened, it will not be possible to guarantee the safety of the joint. Leakage may result which would compromise the function.

Remove:
- The headlining. See Headlining, replacing Headlining, Replacing.





Remove:
- the connector. See Igniter wire connector Igniter Wire Connector.





Remove:
- clips G and D
- the clips at the top of the A-post
- the screw (3) and unhook the IC (inflatable curtain).
(6 and 7 are removed when removing the grab handle)





Remove:
- screws 1, 2 and 8. Lift out the inflatable curtain.
(4 and 5 are removed when removing the grab handle)

Installing the inflatable curtain

Note! If the inflatable curtain module is dropped, it must not be installed.





Install:
- clip C
- screw 1 (screw in until the thread engages only).
Remove the packaging by pulling it straight downwards.

Note! Ensure that no bits of paper remain.

Install:
- screws 2 and 8.
(4 and 5 are installed when installing the grab handles)




Hook on the IC (inflatable curtain). Install screw 3.

Note! It is very important that the hook is correctly installed.

Install:
- clip G.
(6 and 7 are installed when installing the grab handles)
Tighten screws 1-7. Tighten to 10 Nm.

Install:
- The connector
- The headlining. See Headlining, replacing Headlining, Replacing

Caution! When installing the IC (inflatable curtain), part of the decal on the curtain must be ripped off and stuck on the decal in the door opening.