Description of Parameters, Quick Test of the Fuel Tank System

Description of parameters, quick test of the fuel tank system

Leak diagnostic unit pump
(Not available in the quick test of the fuel tank system which is run as part of the diagnostic trouble code (DTC) test)
Graphic display in the quick test of the fuel tank system, vehicle communication socket.
Measurement range 0-400 mA.
The control module calculates the value from the pump in the leak diagnostic unit.
The value varies depending on the pressure in the fuel tank system. Higher pressure results in increased power consumption.

Battery voltage
Measurement range 0-17.95 V.
The value indicates the voltage from the system relay to the engine control module (ECM).
The voltage must not be below 11 V when the quick test of the fuel tank system is run.

Fuel tank system quick test
In order for the quick test to start, the status of this parameter must be: NOT COMPLETED.
- COMPLETED = The control module has completed the quick test / diagnostic of the fuel tank system during the present operating cycle
- NOT COMPLETED = The control module has not completed the quick test / diagnostic of the fuel tank system during the present operating cycle.

Test phase
In order for the quick test to start, the status of this parameter must be: NOT RUNNING.
The parameter indicates the phase of the test.
- REFERENCE 1 = Reference phase for leaks of 0.5 mm and function test of the leak diagnostic unit is running
- MAJOR LEAK = Diagnostic for major leaks is running
- MINOR LEAK = Diagnostic for minor leaks is running
- REFERENCE 2 = Reference phase for leaks and function test of the leak diagnostic unit is running. This phase is only run if leakage is detected in the MINOR LEAK or MAJOR LEAK test phase
- NOT RUNNING = No quick test or diagnostic is running.
For more information about these parameters, see Test phases Test Phases.

Test results for the leak diagnostic unit
The parameter displays the result of the diagnostic for the function of the leak diagnostic unit. The diagnostic is run during test phase REFERENCE PHASE 1.
- NO FAULT FOUND = No fault is detected by the control module
- FAULT FOUND, HIGH SIGNAL = Fault in the leak diagnostic unit detected by the control module. This fault status corresponds to diagnostic trouble code (DTC) ECM-431D, signal too high
- FAULT FOUND, LOW SIGNAL = Fault in the leak diagnostic unit detected by the control module. This fault status corresponds to diagnostic trouble code (DTC) ECM-431D, signal too low
- FAULT FOUND, FAULTY SIGNAL = Fault in the leak diagnostic unit detected by the control module. This fault status corresponds to diagnostic trouble code (DTC) ECM-431D, faulty signal
- FAULT FOUND, SIGNAL MISSING = Fault in the leak diagnostic unit detected by the control module. This fault status corresponds to diagnostic trouble code (DTC) ECM-431D, signal missing.

Test results for the fuel tank system
The parameter indicates the result of the diagnostic for leakage in the fuel tank system. This diagnostic is run when during the MAJOR LEAK or MINOR LEAK test phases.
- NO FAULT FOUND = No leakage is detected by the control module
- FAULT FOUND, MINOR LEAK = Leakage of >0.5 mm detected by the control module. This fault status corresponds to diagnostic trouble code (DTC) ECM-400C, minor leak
- FAULT FOUND, MAJOR LEAK = Leakage of >1 mm is detected by the control module. This fault status corresponds to diagnostic trouble code (DTC) ECM-400C, major leak.