Headlamp Wiper Motor: Service and Repair

Motor, headlamp wiper, replacing

Removal

Preparations
- Switch off the ignition.

Headlamp wiper motor




- Remove Headlamp/bulb, replacing Headlamp/Bulb, Replacing
- Disconnect the connector for the headlamp wiper motor
- Remove the 2 screws from the headlamp wiper motor
- Remove the headlamp wiper motor.

Installation

Headlamp wiper motor
- Position the headlamp wiper motor
- Install the screws. First tighten the inner screw. Then tighten the outer screw. Tighten the screws. Tighten to: 8 Nm
- Connect the connector
- Install Headlamp/bulb, replacing Headlamp/Bulb, Replacing.