Brake Control Module (BCM), Replacing

Control module (ABS), replacing

Preparation

Disconnect the battery lead
Battery, disconnecting Battery Disconnecting.

Preparations for replacement

Note! There is no need to download software when replacing the ABS control module.

Remove the air cleaner (ACL) housing
Brake pipe master cylinder / ABS unit, replacing Brake Pipe Master Cylinder / ABS Unit, Replacing.

Remove the integrated relay / fusebox. Remove the connector for the ABS unit
Brake pipe from hydraulic unit / front wheel / junction, replacing Brake Pipe From Hydraulic Unit / Front Wheel / Junction, Replacing.

Removal

Remove the control module





Remove:
- the pump motor connector
- the four screws. Use a 6 mm torx external socket.
Carefully lift the control module.

Check the control module





Check:
- that the control module is of the correct type (this depends on whether the car is equipped with STC or not)
- that none of the pins or sockets on the connector are damaged
- that there are no contaminants on the mating surfaces between the control module and the ABS hydraulic modulator
- that no part of the control module seals remain on the ABS hydraulic modulator valves.

Installation

Install the control module on the ABS hydraulic modulator




Center the control module on the ABS hydraulic modulator valves before the valves are pushed into place.

Install:
- the control module. Tighten to 1.8 Nm
- the connectors for the pump motor and the control module
- the air cleaner (ACL) housing. Brake pipe master cylinder / ABS unit, replacing Brake Pipe Master Cylinder / ABS Unit, Replacing
- the integrated relay / fusebox. Hydraulic unit, replacing Service and Repair.

Function test
Wheel sensor, front, replacing Wheel Sensor Front, Replacing.