Drive Shafts, Installing

Installing drive shafts

Note! The method is the same for the left and right drive shafts unless otherwise stated. Preparations: Check that the ABS sensor and pulse wheel are free of dirt.

Installing the right drive shaft on the transmission
See Transmission, installing Transmission, Installing.

Installing the left drive shaft on the transmission
See Transmission, installing Transmission, Installing.

Installing the drive shaft on the hub
See Transmission, installing Transmission, Installing.

Installing the ball joint on the stub axle
See Transmission, installing Transmission, Installing.

Tightening the drive shaft screw(s)
See Transmission, installing Transmission, Installing.

Installing the bracket for the brake pipe / ABS cable




Install the bracket for the brake pipe / ABS cable.

Note! Ensure that the ABS sensor seating is absolutely clean!

First clean the ABS sensor using a soft brush. Then install it on the stub axle. Tighten to 10 Nm .

Install the front wheel